您好,歡迎來到易龍商務網!
【廣告】
發布時間:2020-10-31 05:19  





混流泵
使用與保養:Use And
Maintenance
1、經常檢查軸承溫度,軸承箱內應裝70%的鈣基黃油,不得過多或過少,軸承升溫一般不得比周圍超過35°C,軸承的極限溫度不得超過75°C(用手摸感到燙手),若超過應停車檢查原因予以消除。
Check the bearing temperature
regularly.The bearing box should be put 70% butter,it can not be too much or
too little.The temperature rising of bearing can not be more than 35°C higher
than around temperature and the limiting temperature of bearing is 75°C,if the temperature is higher than 75°C, stop to check the reason and adjust it.
4、注意填料的冷卻情況,填料的的調整,不可太緊,以液體能一滴一滴漏出為準,填料太緊發熱、消耗功率。填料太松、使水泵中的液體漏損過多,降低效率。
Pay more
attention to the cooling condition of padding.The padding can not be too tight,
it is ok that the fluid can leak in drops.The temperature will be high if the
padding is too tight which cumes power.If the padding is too loose, the
fluid leaks too much, the efficiency will be lower.
2、離心泵的一般特點
(1)水沿離心泵的流經方向是沿葉輪的軸向吸入,垂直于軸向流出,即進出水流方向互成90°。
(2)由于離心泵靠葉輪進口形成真空吸水,因此在起動前必須向泵內和吸水管內灌注引水,或用真空泵抽氣,以排出空氣形成真空,而且泵殼和吸水管路必須嚴格密封,不得漏氣,否則形不成真空,也就吸不上水來。
(3)由于葉輪進口不可能形成絕 真空,因此離心泵吸水高度不能超過10米,加上水流經吸水管路帶來的沿程損失,實際允許安裝高度(水泵軸線距吸入水面的高度)遠小于10米。如安裝過高,則不吸水;此外,由于山區比平原大氣壓力低,因此同一臺水泵在山區,特別是在高山區安裝時,其安裝高度應降低,否則也不能吸上水來。Startthemotor(paymoreattentionontherotationdirectionofpump)4。
