reducer采購信賴推薦

反力矩支架的安裝：反力矩支架應安裝在減速機朝向的工作機的那一側，以減小附加在工作機軸上的彎矩。 反力矩支架與固定支承聯接端的軸套使用橡膠等彈性體，以防止發生撓曲并吸收所產生的轉矩波動.

Reverse torque support installation: the reverse torque bracket should be installed on the side of the working machine facing the reducer in order to reduce the additional bending moment on the working shaft. The rubber and other elastomers are used in the shaft sleeve of the reverse torque bracket and the fixed support junction to prevent the flexure and absorption of the torque ripple.

通常齒輪減速機已廣泛應用于冶金、礦山、起重、運輸、水泥、建筑、化工、紡織、印染、制藥、等領域。但在這種齒輪減速機的使用有一定的限制,所以,讓我們了解下使用時需要注意什么。

1、高速旋轉不超過1500 r / min。齒輪減速器。

2、齒輪圓周速度不超過20 m / s。

Usually gear reducer has been widely used in metallurgy, mining, lifting, transportation, cement, ctruction, chemical, textile, printing and dyeing, pharmaceutical, and other fields. But there are some restricti on the use of this gear reducer, so let us know what to pay attention to when using it.

1. The high speed rotation does not exceed 1500 R / min. Gear reducer.

2, the circumferential speed of the gear is not more than 20 m / S.

減速機的作用

1)降速同時提高輸出扭矩，扭矩輸出比例按步進電機輸出乘減速比，但要注意不能超出減速機額定扭矩。

2)速同時降低了負載的慣量，慣量的減少為減速比的平方。大家可以看一下一般電機都有一個慣量數值。

The function of the reducer

1) reduce the speed and increase the output torque at the same time. The ratio of the torque output to the multiplying and decelerating ratio of the stepper motor output, but we must be careful not to exceed the rated torque of the reducer.

2) speed reduces inertia of load at the same time, and inertia reduces to the square of deceleration ratio. As you can see, general motors have an inertia value.