輥道價格擇優推薦「多圖」

特別是輸出輥道，過去多采用上述方法對中，但是近有把輥距縮小的傾向，因而采用后一種斜輥布置方式的輥道正在減少。這是為了在軋制薄規格的帶鋼時避免使帶鋼在輥道上因終軋速度高而造成折疊。此外，對于輥道的速度和輥?zhàn)又睆揭惨浞挚紤]好。

In particular, the output roller table used to use the above methods in the past, but recently there is a tendency to narrow the distance between rolls. Therefore, the roller table with the latter one is decreasing. to avoid folding the strip on a thin strip of strip to avoid the high finishing speed of the strip on the roller. In addition, the speed of the roller and the diameter of the roller should be fully cidered.

主要工作輥道緊靠工作機架，它將軋件喂入軋機和接受軋出軋件，因此它是經常參加工作的輥道，故稱主要工作輥道。

軋件長度超過主要工作輥道時，由另一組工作輥道參加工作，這一組輥道叫輔助工作輥道，或稱為延伸輥道。

The main work table is close to the work rack. It will feed the rolling piece into the rolling mill and accept rolling and rolling parts. Therefore, it is a roller table that often works. So it is called the main work roller table.

When the length of the rolled piece exceeds the main work roller Road, another group of working rollers is involved in the work. This group of rolls is called the auxiliary work roller, or the extension roller.

支柱一般采用型鋼焊接而成，上部用螺栓與支架連接，下部用地腳螺栓與地坪固定。按用途支柱可分為對接支柱和中間支柱，兩標準段支架之間采用對接支柱支承，其余（包括端部）則采用中間支柱支承。支柱的設計一般按受壓柱的穩定性來控制。

The pillar is usually welded by the steel type steel, the upper part is connected with the bolt and the support, and the bottom is fixed with the ground bolt and the floor.to the use pillar, it can be divided into the docking pillar and the middle pillar. The two bracket is supported by the docking pillar, while the rest (including the ends) is supported by the intermediate support. The design of the pillar is generally  by the stability of the compression column.

輸送機配件托輥是皮帶輸送機當中一種較為簡單卻又占有大比例的重要輸送零件，托輥在皮帶輸送機當中的主要作用支撐輸送帶和物料的重量。

Conveyor accessories roller is an important part of the belt conveyer which is relatively simple but occupies a large proportion. The main function of the roller in the belt conveyer supports the weight of the conveyer belt and the material.