壓瓦機切刀故障解決方法

(1)上、下限位調整不當或開關損壞,K3、K4接反.參看實驗.

(2)壓瓦機設備電磁閥卡住.關掉油泵,分別按刀起刀落,能聽到"啪啪"吸合聲時, 開啟油泵將刀升到上限位即可.

(3)電磁閥卡住.關掉油泵,分別按壓型升、壓型降,能聽到"啪啪"吸合聲時,開啟油泵將壓型升到上限位即可