圣霖國際750軋機推薦

在軋機設置了上軋輥動態軸向調整。軋機調零后，可以測量和存儲上探頭到上輥軸及下探頭到下輥軸的距離。軋制過程中立輥如失去平衡而引起上輥或下輥的竄動，上輥會與下輥同步調整，從而保證上、下腹板對中并控制腹板和翼緣的尺寸。

There is a dynamic axial adjustment of the upper roll on the universal rolling mill. After the rolling mill is zero, the distance between the upper roll shaft and the lower probe can be measured and stored. During the rolling process, if the neutral rolls lose balance, the upper roller or the lower roll will move. The upper roller will synchronize with the lower roller, so as to ensure the upper and lower plate alignment and  the dimensi of web and flange.

開口式機架由機架底座和上橫梁組成。

開口式機架是型鋼車間常見的一種機架形式。這種機架的優點是制造簡單，裝卸、換輥方便。其缺點是強度和剛度較低，軋輥輥跳值較大，影響產品精度，故只適用于大型軋機。

The open frame is of the frame base and the upper cross beam.  

The open frame is one of the most common forms in the steel workshop. The advantages of this frame are simple manufacturing, loading and unloading, and convenient for roll change. Its disadvantage is that its strength and stiffness are low, the roll roll value is larger and the precision of the product is affected, so it is only suitable for large rolling mill.

據說在14世紀歐洲就有軋機，但有記載的是1480年意大利人達·芬奇（Leonardo da Vinci）設計出軋機的草圖。1553年法國人布律列爾(Brulier)軋制出金和銀板材,用以制造錢幣。此后在西班牙、比利時和英國相繼出現軋機。

It is said that there are rolling mills in Europe in the fourteenth Century, but it is recorded that in 1480, Leonardo Da Vinci (Italian Italian designer Da Finch) designed the draft for rolling mills. In 1553 the French law Adler cloth (Brulier) rolled gold and silver plate, used in the manufacture of coins. Since then, rolling mills have been rolled out in Spain, Belgium and Britain.

按軋制品種、軋機型式和公稱尺寸來命名。“公稱尺寸”的原則對型材軋機而言，是以齒輪座人字齒輪節圓直徑命名。

It is named according to the varieties of rolling, the type of rolling mill and the nominal size. The principle of "nominal size"

For rolling mills, they are named after the gear ring and the pitch diameter of the herringbone gear.